Croton chronomaster reset button11/14/2023 ![]() ![]() The helium which seeped into the watch over a couple of days cannot seep out any faster. This becomes a problem when the vessel is brought back up and depressurized. If the watch stays in this environment for an extended time, helium will continue to seep in to the watch until the air pressure inside the watch (initially surface air pressure) equalizes to the air pressure in the environment. Because helium is the smallest atom, it will seep through the watch's seals under the high air (not water) pressures in this environment. The purpose of a helium release valve is for people who wear their watch inside the helium-saturated environment for an extended period. In some of these, a highly helium-saturated atmosphere is used to avoid the air toxicity effect. Special types of ocean exploration vessels are used by those who do very deep sea research. At approximately 250 feet, air becomes toxic due to changes caused by the high pressures at such depths. Helium does NOT seep into the watch while the watch is in water at any depth. It has nothing to do with normal underwater diving. The purpose and function of the helium relief valve is a common point of confusion. ![]() This adds to the rarity and value of your fine timepiece. Because years of learning and training are required, master watch makers are a rare breed, and therefore mechanical movements are generally found in better watches. At Croton we offer a limited lifetime warranty on your watch so you never have to worry about adjustment charges. If your watch is not keeping accurate time (whether it is going to fast or to slow) you may need a professional watch maker to adjust the movement to your wrist. As every person’s activity level is different a movement is assembled to benefit the average person. To fully power your watch wind the crown 20-30 times. Once the watch stops reset the time and either shake the watch or wind the stem. When the movement is fully powered the watch should keep accurate time for 36-48 Hours. If the watch is not moved the spring will not be wound and the motor will stop. An automatic movement has a perfectly balanced rotor in the back of the watch, and as the watch is moved the rotor turns which winds a spring which in turn powers the motor which keep the hands moving accurately. Mechanical movements are hand assembled and only a master watch maker has the fine honed skills to assemble them properly. ![]() An automatic movement is a type of mechanical movement that runs off the energy created by moving the watch. Movements are the motors which make a watch tick. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |